Fpm101 build by Sadek Baroudi (fingerpunch kb), case designed and 3D printed by me. It uses keyboardio key caps and has matias clicky alps clones. It has a scroll ring around the trackball also!
Can’t wait to use lemmy!
Looks like something from Stargate SG1
If you don’t mind sharing, how much did this cost to build?
Well, that’s a bit hard to nail down, the board is not for sale yet so, I’m not sure the price is nailed down. The plate is laser cut acrylic I got on special from elecrow for $4. The Keboardio keycaps were on sale for $5 a set for the alps version. I went cheap and got Matias clicky switches (alps clones), $40 for 200. I also used half a roll of filament for the case, about $20, and screws I had on hand. All in, disregarding prototype cases, around $280 to $300.
Your sense for aesthetics are always on point. 🔥
I like the style, everything about it looks well thought out and put together. What scroll ring is used on this, and where did you get it?
Thanks! So, I don’t remember the scroll ring part number but sadek designed all the electronics.
@sadekbaroudi do you know the part number offhand?
I may not have tagged him correctly, I need to figure out how to do that on lemmy.
It’s a PERS56. You can get them at DigiKey or mouser. I forget if it’s one or both!
