One wire is more for just a few sensors. I think the STmicro stuff has a 1 wire option. At least one of my programmers has a label for it, but with all my hobby stuff, I’ve never used 1 wire for programming. I have only used it for a temperature sensor as far as I can recall. Everything is either JTAG or UART in my limited experience.
So there’s the OneWire protocol that’s for sensors, different microcontrollers will implement a programming protocol using a single wire, which is what I meant.
Jtag has a clock signal, but is generally 5 lines.
My point being that looking for similar trace lengths because one is a clock signal isn’t sound advice. All the common protocols either don’t use a clock signal, or are more than two lines.
Aren’t most microcontrollers programmed over UART? AVR has their own one wire programming interface, but neither use clock signals.
One wire is more for just a few sensors. I think the STmicro stuff has a 1 wire option. At least one of my programmers has a label for it, but with all my hobby stuff, I’ve never used 1 wire for programming. I have only used it for a temperature sensor as far as I can recall. Everything is either JTAG or UART in my limited experience.
So there’s the OneWire protocol that’s for sensors, different microcontrollers will implement a programming protocol using a single wire, which is what I meant.
Jtag has a clock signal, but is generally 5 lines.
My point being that looking for similar trace lengths because one is a clock signal isn’t sound advice. All the common protocols either don’t use a clock signal, or are more than two lines.