For the v2 it’s actually in the sample klipper config under heater_bed as comments.
Totally understand, I’m thinking about building a small trident or 0.2 at some point for the same reason, I very rarely use the entire bed area of the 2.4
I can see a bit about the solid state relay overheating with too much power, but that’s not the bed. Have I missed something or have you possibly misread something yourself 🤪
I don’t know how small you are thinking, but if it’s V0 size, make sure you’ve seen the “crucible” on 3dprintersforants, it looks cool 😎
For the v2 it’s actually in the sample klipper config under heater_bed as comments.
Totally understand, I’m thinking about building a small trident or 0.2 at some point for the same reason, I very rarely use the entire bed area of the 2.4
I can see a bit about the solid state relay overheating with too much power, but that’s not the bed. Have I missed something or have you possibly misread something yourself 🤪
I don’t know how small you are thinking, but if it’s V0 size, make sure you’ve seen the “crucible” on 3dprintersforants, it looks cool 😎