• frezik@midwest.social
    link
    fedilink
    English
    arrow-up
    4
    ·
    5 months ago

    The problem with LEDs isn’t the bit that emits lights. It’s the power supply, specifically the electrolytic capacitors. Good designs either use higher quality caps, or use designs that avoid electrolytic caps altogether. Either one takes a bit more money, but the market is always in a race to the bottom.

    Long term, I think we should be avoiding traditional light fixtures entirely. It’s better to have a lot of little lights spread over an area rather than a few point sources in the room. That gives us the opportunity to separate the power supply from the lights entirely, like LED strips do.

    • cmnybo@discuss.tchncs.de
      link
      fedilink
      English
      arrow-up
      4
      ·
      5 months ago

      The LEDs will also fail from overheating. LED bulbs don’t last long in fully enclosed fixtures that were designed for incandescent bulbs.

      If the bulb starts flickering, that’s usually a bond wire failure in an LED. When the LED heats up the bond wire loses connection and it will reconnect when it cools down again. The LEDs are in series, so if one fails, the entire bulb goes out. Flickering can also be caused by a capacitor failure in a switch mode supply, but most LED bulbs use linear regulators with a high voltage series string of LEDs now, which also increases the chance of a bond wire failure.

      The early LED bulbs that cost a fortune had huge aluminum heat sinks to keep them cool. The few that I had all lasted until the LEDs got dim.

      • user134450@sh.itjust.works
        link
        fedilink
        English
        arrow-up
        1
        ·
        edit-2
        5 months ago

        The newer designs that use very long, filament-attached LEDs in a large helium filled glass bulb also work quite well, even in a classical light fixture. The helium filling helps with cooling because helium has higher convective heat transfer than air.