GrayBackgroundMusic@lemm.eeM to 3DPrinting@lemmy.worldEnglish · 10 个月前Common printing questionslemm.eeexternal-linkmessage-square84fedilinkarrow-up1380arrow-down136
arrow-up1344arrow-down1external-linkCommon printing questionslemm.eeGrayBackgroundMusic@lemm.eeM to 3DPrinting@lemmy.worldEnglish · 10 个月前message-square84fedilink
minus-squareAhardyfellow@lemmynsfw.comlinkfedilinkEnglisharrow-up4·10 个月前If it is a removable bed, pop that bad boy in the freezer for a bit and the print should pop off. If not then you may want to try some glue stick on the bed before a print which will help the print release since it’ll pull off the glue.
minus-squareArcaneSlime@lemmy.dbzer0.comlinkfedilinkEnglisharrow-up2·10 个月前It is, but muh freezer’s full of food and it is glue sticked lol.
minus-squareAhardyfellow@lemmynsfw.comlinkfedilinkEnglisharrow-up1·10 个月前Damn that’s wild, what type of bed is it?
If it is a removable bed, pop that bad boy in the freezer for a bit and the print should pop off. If not then you may want to try some glue stick on the bed before a print which will help the print release since it’ll pull off the glue.
It is, but muh freezer’s full of food and it is glue sticked lol.
Damn that’s wild, what type of bed is it?
Ender 5 glass bed.