Hi guys as title suggests I have a pi 4b 4gb and basically I want to connect it to my isp provided router (wired connection via a lan cable) and run an openvpn config on it and then connect it to an access point that i already have (this one is wired too via a usb to RJ45 adapter and lan cable). I know that I need to flash openwrt image on an sdcard and install it on pi4 but I don’t know how to configure openwrt after that and honestly the guides on the forums and internet are a little confusing (I’m not that tech savy) also I read that not all usb to RJ45 adapters work with openwrt on pi4 but I don’t know which one to buy. can anyone show me a fool proof guide or tell me what I need to do?
You have the pi, give it a go.
If it’s inadequate then i’d recommend a used fanless thin-client type PC, such as a Wyse 5070, just make sure it comes with PSU and a few GB of RAM and SSD. And check reports of how much power it uses at idle.
Thanks I will try running Wireguard on pi4. I never considered tin-clients before. What kind of OS these have? Can they run VPN clients?
Usually they’re normal x86 PCs with nothing unusual about them so just your Linux/BSD distro of choice. You can look up the processor model to see what crypto acceleration it can do, or see if there’s any wireguard benchmarks available.
Some have interesting processors like PowerPC, or other strange hardware, but avoid them unless interesting is what you’re after.
Sounds interesting I’m looking for a good mikrotik router right now. Going to look for these too thanks