This just happened for a second time… I’m running octoprint on a windows desktop computer that lives next to the printer (no raspberry pi for me yet).

Twice now, it has disconnected mid-print. The printer and PC are both online and physically connected. Disconnecting and reconnecting in octoprint works, and I have been manually checking the last gcode sent successfully in the terminal and copying the remaining code out of the file from there and printing that - it works but if it has been disconnected for a while before I notice, the spot where the extruder was sitting gets a little melty and there are some artifacts in the print.

Is there any octoprint plug in that can automate this process so I don’t have to manually edit the gcode? Or any tips on preventing disconnects?

I’m pretty new to this whole world of 3d printing and even newer to octoprint so I may be missing something obvious.

Thanks!

  • Jtskywalker@lemm.eeOPEnglish
    3·
    1 year ago

    Octoprint is a software to manage a printer running marlin firmware.

    Klipper is a different printer firmware, and is not something you can use to manage a printer running marlin.

    I do want to look at flashing klipper to my sv06 someday but right now I’m just trying to print stuff without manually moving an SD card every time.

    • LazaroFilm@lemmy.worldEnglish
      1·
      1 year ago

      I used Octoprint for a few years before switching to Klipper. Octoprint was good but Klipper was like discovering that you can fly.

      • Jtskywalker@lemm.eeOPEnglish
        1·
        1 year ago

        Are you using mainsail to interface with the printer? That is what I have seen most people recommend for klipper printers

        • LazaroFilm@lemmy.worldEnglish
          1·
          1 year ago

          Mainsail on my computer. KlipperScreen on my printers touchscreen. MobileRaker on iOS. I also use TelegramMoonraker to interact when away without opening ports. All manages via Moonraler (klipper’s API)