My resin printer was powered off with resin in the vat for about 7 months. Last night I turned it on, gave it a job, and I woke up to a successful print.

My inkjet printer was powered off for 2 weeks. Last night I turned it on, gave it a job, and was instantly disappointed with a streaky, blotchy output. Running a clean cycle just made the output worse.

Why are 2D printers so terrible despite decades of development? What are some 2D printers this community has had good interactions with/would recommend?

  • Anonymouse@lemmy.world
    link
    fedilink
    English
    arrow-up
    1
    ·
    11 months ago

    I switched to Brother after my HP updated itself when I forgot why I had a particular firewall rule, deleted it and let the printer onto the internet to roam. It pulled down a patch which added an amazing security feature to block the use of the toner that I bought. I bricked it while trying to downgrade the firmware (after placing an order for their “certified” toner). I tried returning the toner, but couldn’t and eventually took it tongue recycling center, swearing to never buy HP again.